Some help with ATM workable track please

[paulh]

Folks,
The instructions for the above have me confused:

The order of construction I'm fine with, but its the first line of english says no glue needed, then talks about removing the pins from sprue once glue is set.

Any ideas?

P

[TRM]

Hi Ya Paul!

Not sure which particular ATM track you are using, but this might help. I pulled these pics off Armorama - armorama.kitmaker.net/modules.php?op=modload&name=Reviews&file=index&req=showcontent&id=5605 . It shows the pin caps still attached to the spue to which I can assume they would be glued and cut later after drying.






Hope some of this help!! Good luck!

[paulh]

Thanks for that T- clears things up somewhat.

[jackh]

Paul - if the tracks you're working with are the same as T show photos of? There should be no need for glue since they normally are a tight fit and if you use glue they are not so workable anymore .

[406 Silverado]

Jack is correct. No glue, but if you need to, then only use glue on every other pin. Or one per link. This will make it still work somewhat.

[paulh]

Jack, Rob- thank you both- makes a lot more sense now.
P

[spud]

i have a set of these and they have been in teh box and that box has be moved about 500 times in its 20 years and they are still in one peice one they are on they wont come apart

[paulh]

Excellcent- thank you spud- any all for such prompt and useful advice.
P

[eastrock]

Hey Paul, if your asking for a workable track... mine is glued at the center... I did use the bronco workable tracks for the chally, you need to mate the male and female part.